| |
Main
Date: 31 May 2006 18:59:45
From: Rick Knight
Subject: Kettle Conversion
|
Anyone here used the Weld-B-Gone weldless kettle fitting/ball valve? I
have an aluminum kettle that I want to install one into. It requires a
7/8" diameter hole. Problem is, I'm having a heck of a time finding a 7/8"
bit for my 3/8" drill. I've looked at 7/8" hole punches from Greenlee, but
they'er a bit expensive for a single use. Anybody have any suggestions for
cutting this hole?
Thanks a bunch
Rick Knight
|
|
| |
Date: 31 May 2006 16:45:26
From: MDixon
Subject: Re: Trying to get a white beer to look like a white beer
|
KAB <kbrown@uvi.edu > wrote in message
news:1149100019.522836.300950@i39g2000cwa.googlegroups.com...
> If you want a fairly good overview of brewing a Wit listen to The Jamil
> Show 03-13-06 on the Brewing Network.(www.thebrewingnetwork.com) It is
> on page 5 of the archived shows. Mostly for all grain brewing, it's
> hard to get an authentic Wit using only extract.
If he's not ready to go AG, then Grape and Granary has a fine extract
Witbier. I just trashed the recipe for their version while going through
years of stuff recently. If you need an AG version, my version is difficult
to beat...
Cheers,
Mike
www.ipass.net/mpdixon/
|
|
